The new ICC1-IRX IR TV Controller delivers economical 1-way control for TV power, volume, and channels, receiving iCC-Net network commands over the same broadband coax that carries the CATV channels. Compact in size and price, the ICC1-IRX now features power current sensing using the optional CSM1 sensor from Xantech.
Manages channel access by changing the TV’s internal available channel list
Delivers absolute power control using the Xantech CSM1 power current sensor
Networks up to 4,000 TVs through the ICE-HE Ethernet Head-End
Receives 1-way individual and zone commands from a single RS-232 port on the HE
Operates over same RF coax cable as CATV channels
Exclusive SmartZone architecture controls hundreds of controllers with a single command
Low-loss internal RF tap saves amplification and installation costs
Provides LED feedback for network, IR control, and power status
Restores all power and channel status after loss of power from data stored in non-volatile memory
Mounts on the back of the TV for simplified control and RF installation
Operates with Contemporary Research Display Express software as well as from RS-232 protocol from a custom-programmed PC or control system
Senses power status from optional CSM1 power current sensor, or optional CC-HSD scan sensor for older tube TVs
Includes CC-IRE IR Emitter, RF loop cable, mounting Velcro, and 12VDC power supply (U.S. only)
ROHS Compliant - Yes
Systems Controlled - Displays
Warranty - Yes
Spec Sheet available - Yes
DC Voltage:
12 Volts
Depth:
86.36 mm
Height:
27.94 mm
Width:
139.70 mm
Product Weight:
0.23 kg
Physical:
Enclosure: All aluminum with durable black powder coat paint
Mounting: Mounts at rear of TV
Front Panel:
RF In: 'F', female, 75 ohm impedance, RF from CATV system, iCC-Net control
RF Out: ‘F', female, 75 ohm impedance, RF to TV, Low-loss internal tap - less than -1.5 dbmV loss
Net LED: Green LED for iC-Net bus and DC power, flashes once per second if active
IR Out: 3.5mm jack for CC-IRE IR Emitter cable or compatible CC-IRS serial cable, Supports carrier frequencies up to 62 KHz
IR Out LED: Red LED lights when sending IR commands
Power Sensor:
Tip+:3.5mm jack for included CC-HSD scan sensor or 5V logic-level input
CSM: 3.5mm jack of Zantech CSM1 Power Current Sensor
LED: Red LED lights when sensor indicates power on
Power In: 2.1mm coaxial jack (inside center conductor positive), 75 mA maximum, 11.5 to 16.5 VDC, 12 VDC typical (may be unregulated)
DIP Switches S1 and S2: Located on bottom of unit, sets IR code operation and device number
ICC-Net:
Operation: 1-way control, carried over the same RF coax connection as TV channels
Data Receive: Mid-band VHF, 74.7MHz, sent from IC Head-End Network Controller , -25 to +35 dBmV signal level
CC-HSD Scan Sensor:
Range: Senses presence of TV scanning, from 15-35 KHz, magnetic pick-up
Includes: 3.5mm plug, 4ft. cable, stick-on TV sensor
Includes:
Space-saving 12 VDC 500 mA digital switching power supply (North American shipments only
CC-IRE IR Emitter