Microphones : Headworn Microphones : Audio-Technica - BP893cW

Omnidirectional Condenser Headworn Microphone

Model: BP893cW

Outstanding clarity and intelligibility
Lightweight and ergonomic design
Extremely unobtrusive, 1-inch flexible boom
Secure over-the-ear placement
Extended frequency response for natural vocal reproduction

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

BP893 omnidirectional condenser headworn microphone, less power module. 1.4 m (55") permanently attached miniature cable terminated with locking 4-pin connector for use with Audio-Technica UniPak® body-pack wireless transmitters. Includes AT8440 cable clip, two AT8157 windscreens, two AT8156 element covers, a moisture guard, and a carrying case. Available in black and beige, wired and wireless models.

Outstanding clarity and intelligibility
Lightweight and ergonomic design
Extremely unobtrusive, 1-inch flexible boom
Secure over-the-ear placement
Extended frequency response for natural vocal reproduction
Fixed-charge back plate, permanently polarized condenser element
Locking 4-pin microphone output connector compatible with included power module and all Audio-Technica UniPak body-pack wireless transmitters
UniSteep filter provides a steep low-frequency attenuation to improve sound pickup without affecting voice quality

Headset Mic Type - Condenser
Microphone Connectivity - Wired
Microphone Type - Condenser
Polar/Pickup Pattern - Omnidirectional
Warranty - Yes
Spec Sheet available - Yes

Cable Length: 1.40 m
Cable Length: 140 cm
Maximum Frequency Response (Bandwidth): 20000 Hz
Maximum Frequency Response (Bandwidth): 20 kHz
Minimum Frequency Response (Bandwidth): 20 Hz
Minimum Frequency Response (Bandwidth): 0.02 kHz
Impedance: 245 ohm
Maximum SPL (Sound Pressure Level): 114 dB
Sensitivity: -34 dB
Signal to Noise Ratio: 68 dB
Current Draw: 0 Amps
DC Voltage: 52 Volts
Product Weight: 0 kg
Warranty (Length/Type): 2 Years/Limited End-User
Low Frequency Roll-off: 80 Hz 18 dB/octave (wired only)
Open Circuit Sensitivity: -34 dB (19.9 mV) re 1V at 1 Pa
Phantom Power Requirements: 11 to 52 V DC 2 mA typical (wired only)
Current Consumption: 0.10 mA typical at 5V (wireless only)
Voltage Range: 2.5 to 11 V (wireless only)
Weight:
Dimensions:
OUTPUT CONNECTOR (POWER MODULE): Integral 3-pin XLRM-type
Cable: 1.4 m (55") long (permanently attached to microphone), 1.6mm (0.06") diameter, 2-conductor shielded cable with locking 4-pin connector (wired only)
AUDIO-TECHNICA CASE STYLE: M31

BP893 Submittal Sheet 426 kb - Data Sheet

Project List

Find a Dealer

Find a Distributor

Suggested Products

Micro-headworn Condenser Microphone with TA4F Connector, Black

by Electro-Voice

Micro-headworn Condenser Microphone with TA4F Connector, Beige

by Electro-Voice

Special Projects Headworn Condenser Vocal Microphone with TA4F Connector

by Electro-Voice