Signal Processing Systems : Audio Transformers : ARX Systems - MSX 48

Transformer Isolated Microphone/Line Splitter

Model: MSX 48

16 x Hardwired balanced XLR input and main outputs: pin 3-, pin 2 +, pin 1 ground
16 x Hardwired transformer isolated balanced XLR monitor splits: in 3-, pin 2 +, pin 1 floating (not connected)
Numbered marker panel for labeling individual channel assigns
16 x Hardwired transformer isolated balanced XLR auxiliary splits: pin 3–, pin 2 +, pin 1 floating (not connected)
2 x D Sub connectors for monitor splits

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

MSX 48 is a transformer isolated ultra low noise microphone/line splitter with 16 channels. Each of these channels has a direct looped main/FOH feed, and a transformer isolated monitor split on the front panel. On the rear panel is an auxiliary transformer isolated split ideal for use with a remote recording truck or TV feed. Duplicates of the monitor and aux splits are also provided on two sets of dual 25 pin D connectors on the rear panel, wired to Tascam wiring protocol.

16 x Hardwired balanced XLR input and main outputs: pin 3-, pin 2 +, pin 1 ground
16 x Hardwired transformer isolated balanced XLR monitor splits: in 3-, pin 2 +, pin 1 floating (not connected)
Numbered marker panel for labeling individual channel assigns
16 x Hardwired transformer isolated balanced XLR auxiliary splits: pin 3–, pin 2 +, pin 1 floating (not connected)
2 x D Sub connectors for monitor splits
2 x D Sub connectors for auxiliary splits
Screw terminal chassis ground point
Sixteen channel/three way split per channel
Passive unit - no power required
Ultra low noise design
D sub connectors on rear panel for monitor and auxiliary splits (Tascam wiring)
Transformer balanced inputs and outputs
Inputs and main outputs hard wired to pass phantom power
Intuitive, 'user friendly' layout
Flawless audio performance

Input Impedance: 300 ohms
Frequency Response: 30Hz to 20 KHz ± 1dB
Input Impedance: 300 ohms
Frequency Response: 30Hz to 20 KHz ± 1dB
Input Impedance: 300 ohms
Frequency Response: 30Hz to 20 KHz ± 1dB
Input Impedance: 300 ohms
Output Impedance: 2 secondaries @ 600 Ohms each
Frequency Response: 30Hz to 20 KHz ± 1dB
Maximum Output Level: + 20 dBm
THD at Max Output: 0.2% 30 Hz to 20KHz @ 20dBm
Insertion Loss: 0.5dB @ 1 KHz 600 Ohm source & load
Input Connectors: 3 pin female XLR wired Pin 2 + Hot, Pin 3 – Cold
Main Output: 3 Pin male XLR wired Pin 2 + Hot, Pin 3 – Cold
Monitor and Aux Output: 3 pin male XLR wired Pin 2 + Hot, Pin 3 – Cold. Audio grounds not connected; Pin 1 is floating

MSX 48 79 kb - Brochure

Project List

Find a Dealer

Find a Distributor

Suggested Products

System-to-System Interface

by RTS