Signal Processing Systems : Audio Transformers : ARX Systems - MSX 12

Transformer Isolated Microphone/Line Splitter

Model: MSX 12

Four channel/three way split per channel
Passive unit - no power required
Ultra low noise design
Transformer balanced inputs and outputs
Inputs and main outputs hard wired to pass phantom power

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

Its intuitive layout and clear, uncluttered labelling enables a quick and easy solution to the increasing complexity of today’s standards of audio production. The ARX MSX 12 Transformer isolated Microphone/Line Splitter has been developed to deliver noise-free audio splitting with minimal setup time. Its intuitive layout and clear, uncluttered labelling enables a quick and easy solution to the increasing complexity of today’s standards of audio production.The MSX 12 is a totally passive device requiring no power, and consists of Four channels of transformer isolated ultra low noise Microphone/Line Splitter. Each of these channels has a direct looped Main/FOH feed, and a transformer isolated Monitor split on the front panel.On the rear panel is an Auxiliary transformer isolated split ideal for use with a remote recording truck or TV feed.

Four channel/three way split per channel
Passive unit - no power required
Ultra low noise design
Transformer balanced inputs and outputs
Inputs and main outputs hard wired to pass phantom power
Intuitive, 'user friendly' layout
Flawless audio performance
4 x hardwired balanced XLR input and pin 3–, pin 2 +, pin 1 ground main outputs
4 x hardwired transformer isolated balanced XLR monitor splits: pin 3–, pin 2 +, pin 1 floating (not connected)
Marker panel for labelling individual channel assigns
4 x Hardwired transformer isolated balanced XLR auxiliary splits: Pin 3–, Pin 2 +, Pin 1 floating (not connected)
2 x D Sub connectors for monitor splits
2 x D Sub connectors for auxiliary splits
Screw terminal chassis ground point

Input Impedance: 300 ohms
Output Impedance 2 secondaries: 600 ohms each
Frequency Response: 30 Hz to 20 KHz ± 1dB
Maximum Output Level: +20 dBm
THD at Maximum Output: 0.2 % at 30 Hz to 20 KHz, 20 dBm
Insertion Loss: 0.50 dB at 1 KHz (600 ohm sources and load)
Input Connectors: 3 pin female XLR wired pin 2 + hot, pin 3 – cold
Main Output: 3 Pin male XLR wired pin 2 + hot, pin 3 – cold
Monitor and Aux Output: Split 3 pin male XLR wired pin 2 + hot, pin 3 – cold. audio grounds not connected, pin 1 is floating

Transformer Isolated Microphone/Line Splitter 518 kb - Brochure

Project List

Find a Dealer

Find a Distributor

Suggested Products

System-to-System Interface

by RTS