iSwitch is a unique precision piece of test equipment, being able to individually send a choice of two program sources to 12 pairs of powered loudspeakers, making it ideal for batch testing or demonstrating.Its ultra low noise figures come from extensive use of premium components, plus care and attention to board design and layout. The result is superb, transparent audio quality and the headroom to accurately reproduce the most demanding input signal. A and B Input gains are adjustable from Off through to +6 dB via level controls on the front panel. LED status indicators show which input is currently active.
Inputs and Outputs are electronically balanced on Tip-Ring-Sleeve jack connectors
Interlocking switches prevent more than one Output pair being selected at a time
Ultra low noise figure
Provides a truly innovative solution to testing multiple powered speaker systems
Frequency Response:
10Hz to 20KHz ±0.25 dB
Width:
482 mm 19 in
Height:
44 mm 1¾ in
Depth:
155 mm 6 in
Gain Off:
+6 dB
Input A and B Impedance:
40 kohm
Input Headroom:
+21 dB
Outputs 1 to 16 Impedance:
100 ohm
Output Level:
(Max)+26 dB
Frequency Response:
10Hz to 20KHz ±0.25 dB
Signal-to-Noise Ratio:
-96dB unweighted, -102dB A weighted
Distortion @ Unity Gain:
.0025% THD, 0dB @ 1 KHz
Dynamic Range:
122 dB
Input Connectors:
Balanced Tip-Ring-Sleeve jack, wired Tip +, Ring –, Sleeve Audio Earth/Ground
Output Connectors:
Balanced Tip-Ring-Sleeve jack, wired Tip +, Ring –, Sleeve Audio Earth/Ground
Staus Indicators:
Input A or B LEDs, Outputs 1 to 16 LEDs
Power Requirements:
100 to 120/220 to 240V AC, 50/60 Hz, 8VA (8 watts) 3 pin IEC connector