BSX 16 is 1 or 2 in, 16 out transformer isolated active broadcast splitter. Developed to deliver the performance required by the increasingly sophisticated level of today’s standards of E.N.G and broadcast audio production. Numbered marker panels above or below each split provides a space where individual connections can be noted. Internally, powerful RF input filtering removes both common mode and differential interference at ultrasonic frequencies and above. High CMRR is achieved by the use of precision components throughout. Internal transformer based power supply is triple shielded to get the maximum benefit from the ultra low noise design of the circuitry. To sum up, this feature packed two RU device is the answer wherever multiple transformer output splits from up to 2 input signals are required.
16 way active press/broadcast splitter with transformer isolation
Splits 1 to 8 line level out and 9 to 16 switchable mic or line level
Dual inputs with individual gain and level controls
Dual loop outputs
Additional XLR PA output connector on rear
Ultra low noise design
'SilentSwitch' 48V phantom power switching
–20 dB pad switch on inputs
Headphone monitoring
LED meter on output
Electronically balanced inputs
Transformer isolated outputs
Optional 12 V DC powering
Intuitive and user friendly layout
Flawless audio performance
Spec Sheet available - Yes
Signal to Noise ratio (Gain set at 20 dB) unweighted:
–88 dB –94dB ‘A’ weighted
Distortion at Unity Gain:
0.05 % 1 KHz
Input Gain:
10 dB through to 50 dB
Input Impedance:
4 k ohms
Input Headroom:
+21 dB
Input Pad:
–20 dB attenuation
Maximum Output:
+21 dB
Output Impedance:
300 ohms Transformer Balanced
Output Level (maximum):
+20 dB Line out level: 10dB mic output level
Frequency Response:
40Hz to 20KHz ±0.5 dB
Phantom Power Switchable Global:
+48 VDC slow turn on/turn off
Transformer Type:
Low noise shielded
Outputs:
1 to 8 are Line Level (0dB)
Outputs:
9 to 16 are switchable mic (-30dB), line (0dB) output Level
Dynamic Range:
109
Headphone Output:
500 mW at 8 ohms output
Headphone Connector:
6.5mm TRS Jack wired mono
LED output level indicators:
-40, 0, +6 dB
AC Mains Input:
Fused IEC socket
AC Power:
100 to 120 V AC/2 A, 220 to 240 V AC/10 VA Replace fuse with correct value only: 100 to 120 V AC/2 A, 220 to 240 V AC/1 A